Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

DTC    C1531    ECU Malfunction

for Preparation Click here


DESCRIPTION

This circuit supplies electric power to the power steering solenoid valve. The power steering solenoid valve is built into the vane pump assembly.
The power steering ECU controls the output current to the power steering solenoid valve in accordance with the steering angle signal, steering zero point memory, vehicle speed signal and engine speed signal, adjusting the amount of power steering assist.

DTC No.
DTC Detection Condition
Trouble area
C1531
A short or open in the solenoid valve circuit
  1. Harness or connector
  2. Vane pump assembly (Power steering solenoid valve)
  3. Power steering ECU assembly

WIRING DIAGRAM


C210556E10


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM (SOLENOID CURRENT)
  1. Turn the ignition switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Chassis / PPS / Data List.

  1. According to the display on the Techstream, read the Data List.

    PPS 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Solenoid Current
    Solenoid Current/
    Min.: 0 mA
    Max.: 1000 mA
    200 to 950 mA
    The engine is running and the steering wheel is being turned.

    OK:
    The normal condition value is displayed the Techstream.



NG
Go to step 2
OK

REPLACE POWER STEERING ECU ASSEMBLY (Click here)  

2.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - POWER STEERING SOLENOID VALVE)
  1. Disconnect the power steering ECU and power steering solenoid valve connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H117-7 (SOF+) - D51-2 (SOF+)
    Always
    Below 1 Ω
    H117-8 (SOF-) - D51-1 (SOF-)
    Always
    H117-7 (SOF+) - Body ground
    Always
    10 kΩ or higher
    H117-8 (SOF-) - Body ground
    Always



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT VANE PUMP ASSEMBLY (POWER STEERING SOLENOID VALVE)
C225484E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    6.7 to 7.3 Ω

  1. Connect the battery positive (+) lead with a 21 W bulb to terminal 2 and the negative (-) lead to terminal 1 of the solenoid valve connector. Then check that the valve moves and makes an operating noise.

    OK:
    The solenoid makes an operating sound.

    Text in Illustration 
    *a
    Component without harness connected
    (Power Steering Solenoid Valve)
    Result 
    Result
    Proceed to
    OK
    A
    NG (for 1UR-FE)
    B
    NG (for 3UR-FE, 3UR-FBE)
    C



B
REPLACE VANE PUMP ASSEMBLY (Click here)

C
REPLACE VANE PUMP ASSEMBLY (Click here)
A

REPLACE POWER STEERING ECU ASSEMBLY (Click here)