DTC U0104 Lost Communication with Driving Support ECU |
| DTC Code | DTC Detection Condition | Trouble Area |
| U0104 | There is no communication from the distance control ECU assembly. |
|

| 1.PRECAUTION |
| NEXT | |
| 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the CAN main wire and CAN branch wire.
| NEXT | |
| 3.CHECK FOR OPEN IN CAN BUS WIRE (DISTANCE CONTROL ECU ASSEMBLY CAN BRANCH WIRE) |
![]() |
Disconnect the A43 distance control ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A43-8 (CANH) - A43-9 (CANL) | Ignition switch off | 54 to 69 Ω |
| *a | Rear view of wire harness connector (to Distance Control ECU Assembly) |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (DISTANCE CONTROL ECU ASSEMBLY - BATTERY AND BODY GROUND) |
![]() |
Connect the cable to the negative (-) battery terminal.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A43-1 (B) - Body ground | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A43-12 (GND) - Body ground | Always | Below 1 Ω |
| *a | Rear view of wire harness connector (to Distance Control ECU Assembly) |
|
| ||||
| OK | ||
| ||