Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    C1AB5    Open in Outer Mirror Indicator(Slave)

for Preparation Click here


DESCRIPTION

This DTC is stored when the blind spot monitor sensor LH detects an open in the blind spot monitor indicator LH.

DTC Code
DTC Detection Condition
Trouble Area
C1AB5
With the blind spot monitor main switch assembly (warning canceling switch assembly) on, the current flowing to the indicator is below a specified value when indicator operation voltage is sent to the indicator.
  1. Blind spot monitor indicator LH
  2. Outer rear view mirror assembly LH
  3. Harness or connector
  4. Blind spot monitor sensor LH

WIRING DIAGRAM


E221720E04


INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    OK:
    No DTCs are output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.CHECK HARNESS AND CONNECTOR (OUTER REAR VIEW MIRROR ASSEMBLY LH - BLIND SPOT MONITOR SENSOR LH AND BODY GROUND)
  1. Disconnect the O46 blind spot monitor sensor LH connector.

  1. Disconnect the M5 outer rear view mirror assembly LH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    O46-6 (OMIL) - M5-9 (BSL+)
    Always
    Below 1 Ω
    M5-5 (LP-) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT BLIND SPOT MONITOR INDICATOR LH


    E231442E01
  1. Remove the outer rear view mirror assembly LH (Click here).

  1. Apply battery voltage to the terminal of the outer rear view mirror assembly LH, and check that the blind spot monitor indicator turns on.

    Standard:
    Connection
    Specified Condition
    Battery positive (+) → 9 (BSL+)
    Battery negative (-) → 5 (LP-)
    Indicator turns on

    Text in Illustration 
    *1
    Blind Spot Monitor Indicator LH



NG
Go to step 4
OK

REPLACE BLIND SPOT MONITOR SENSOR LH  

4.INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH


    E231117E02
  1. Remove the outer rear view mirror assembly LH (Click here).

  1. Remove the outer rear view mirror glass LH (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    9 (BSL+) - 7 (+)
    Always
    Below 1 Ω
    5 (LP-) - 5 (-)
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Vehicle Side
    *b
    Outer Rear View Mirror Glass LH Side



NG
REPLACE OUTER REAR VIEW MIRROR ASSEMBLY LH (Click here)
OK

REPLACE OUTER REAR VIEW MIRROR GLASS LH (BLIND SPOT MONITOR INDICATOR LH) (Click here)