BLIND SPOT MONITOR SYSTEM > Turn Signal Switch Circuit |

| 1.READ VALUE USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Master Side Turn Signal | State of the master side turn signal / OFF or ON | ON: Right turn signal received OFF: Right turn signal not received | - |
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Slave Side Turn Switch | State of the slave side turn signal / OFF or ON | ON: Left turn signal received OFF: Left turn signal not received | - |
| Result | Proceed to |
| The display changes as shown above when the right turn switch or left turn switch is operated. | A |
| The display does not change as shown above when the right turn switch is operated. | B |
| The display does not change as shown above when the left turn switch is operated. | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - HEADLIGHT DIMMER SWITCH ASSEMBLY) |
Disconnect the P25 blind spot monitor sensor RH connector.
Disconnect the H11 headlight dimmer switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| P25-2 (BSTR) - H11-13 (TR) | Always | Below 1 Ω |
| P25-2 (BSTR) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR LH - HEADLIGHT DIMMER SWITCH ASSEMBLY) |
Disconnect the O46 blind spot monitor sensor LH connector.
Disconnect the H11 headlight dimmer switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| O46-2 (BSTL) - H11-15 (TL) | Always | Below 1 Ω |
| O46-2 (BSTL) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||