Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

BLIND SPOT MONITOR SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected areas below.


 
Symptom
Suspected Area
See page
System does not operate at all
Proceed to "Power source circuit"
Click here
Proceed to "Main switch circuit"
Click here
Replace blind spot monitor sensor RH
Click here
System cannot be turned off
Proceed to "Main switch circuit"
Click here
Replace blind spot monitor sensor RH
Click here
Blind spot monitor indicator for the right side does not illuminate
Blind spot monitor beam axis inspection
Click here
Replace outer rear view mirror glass RH
Click here
Replace outer rear view mirror assembly RH
Click here
Replace blind spot monitor sensor RH
Click here
Blind spot monitor indicator for the left side does not illuminate
Blind spot monitor beam axis inspection
Click here
Replace outer rear view mirror glass LH
Click here
Replace outer rear view mirror assembly LH
Click here
Replace blind spot monitor sensor LH
Click here
Blind spot monitor indicator for the right side is constantly illuminated
Blind spot monitor beam axis inspection
Click here
Replace blind spot monitor sensor RH
Click here
Blind spot monitor indicator for the left side is constantly illuminated
Blind spot monitor beam axis inspection
Click here
Replace blind spot monitor sensor LH
Click here
Blind spot monitor indicator for the right side does not blink
Refer to "Turn Signal Switch Circuit" in the Lighting (Ext) section
Click here
Refer to "Turn Signal Switch Circuit"
Click here
Replace blind spot monitor sensor RH
Click here
Blind spot monitor indicator for the left side does not blink
Refer to "Turn Signal Switch Circuit" in the Lighting (Ext) section
Click here
Refer to "Turn Signal Switch Circuit"
Click here
Replace blind spot monitor sensor LH
Click here
Blind spot monitor indicator for the right side is constantly blinking
Replace blind spot monitor sensor RH
Click here
Blind spot monitor indicator for the left side is constantly blinking
Replace blind spot monitor sensor LH
Click here
Blind spot monitor system warning message in the multi-information display is constantly displayed
Check the outside temperature
-
Check whether a Toyota genuine bumper is installed
-
Check that there is no foreign matter adhering to the bumper
-
Check that there is no foreign matter between the sensor and the bumper
-
Proceed to "Power Source Circuit"
Click here
Replace blind spot monitor sensor RH
Click here
Replace blind spot monitor sensor LH
Click here
Replace combination meter assembly
Click here
Blind spot monitor system warning message in the multi-information display does not display during initial check
Proceed to "Power Source Circuit"
Click here
Replace blind spot monitor sensor RH
Click here
Replace blind spot monitor sensor LH
Click here
Replace combination meter assembly
Click here