Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM

TOYOTA PARKING ASSIST-SENSOR SYSTEM > Clearance Warning ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit is the power source circuit to operate the clearance warning ECU assembly.

WIRING DIAGRAM


E300605E02


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (DRIVE MONITOR SWITCH - BATTERY)


    B156356E04
  1. Disconnect the drive monitor switch connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    J2-7 (IG) - Body ground
    Ignition switch ON
    11 to 14 V
    Ignition switch off
    Below 1 V

Text in Illustration 
*a
Front view of wire harness connector
(to Drive Monitor Switch)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT DRIVE MONITOR SWITCH
  1. Remove the drive monitor switch (Click here).

  1. Inspect the drive monitor switch (Click here).



NG
REPLACE DRIVE MONITOR SWITCH (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - DRIVE MONITOR SWITCH AND BODY GROUND)
  1. Disconnect the H131 clearance warning ECU assembly connector.

  1. Disconnect the J2 drive monitor switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H131-11 (IG) - J2-8 (SK)
    Always
    Below 1 Ω
    H131-11 (IG) or J2-8 (SK) - Body ground
    Always
    10 kΩ or higher
    H131-16 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)