Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio and Display Type)

AUDIO AND VISUAL SYSTEM (for Radio and Display Type) > No Sound can be Heard from Speakers

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY
  1. In sound output setting mode, set volume, fader and balance to the initial values and check that the sound is normal.

    OK:
    Audio system returns to normal.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END (SETTINGS ARE DEFECTIVE)