CRUISE CONTROL SYSTEM > Cruise Main Indicator Light Circuit |
| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (COMBINATION METER) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Combination Meter / Active Test.
Check the CRUISE main indicator light by performing the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Indicat. Lamp Cruise | CRUISE main indicator light | Indicator light BLINK/OFF | - |
|
| ||||
| OK | |
| 2.READ VALUE USING INTELLIGENT TESTER (CRUISE CONTROL) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Cruise Control / Data List.
Check the Data List for proper functioning of the CRUISE main indicator light.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| CCS Indicator M-CPU | Cruise indicator signal (Main CPU) / ON or OFF | ON: "CRUISE" on OFF: "CRUISE" off | - |
|
| ||||
| OK | ||
| ||