COMBINATION METER > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE FRONT DOOR SCUFF PLATE LH |
| 4. REMOVE COWL SIDE TRIM BOARD LH |
| 5. REMOVE INSTRUMENT SIDE PANEL LH |
![]() |
Using a moulding remover, detach the 7 claws and remove the side panel.
| 6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY |
![]() |
Remove the 2 <A> bolts.
Detach the 9 clips and claw.
![]() |
Detach the 2 claws and remove the sensor.
Remove the finish panel and then disconnect the connectors.
| 7. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
![]() |
Detach the 4 claws and remove the instrument panel finish panel retainer.
![]() |
Disconnect the 2 connectors and wire harness clamp.
Detach the 12 clips and remove the finish panel.
| 8. REMOVE COMBINATION METER ASSEMBLY |
![]() |
Remove the 4 screws and combination meter assembly.
![]() |
Disconnect the connector and detach the wire harness clamp.