Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio and Display Type)

AUDIO AND VISUAL SYSTEM (for Radio and Display Type) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
Use these procedures to troubleshoot the audio and visual system.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      1. If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.BASIC INSPECTION
    1. Turn the ignition switch to ON.

    2. Check whether or not the radio receiver turns on.
      Result 
      Result
      Proceed to
      Radio receiver turns on
      A
      Radio receiver does not turn on
      B



    B.
    Go to step 6
    A


    4.CHECK FOR DTC
    1. Check for DTCs and note any codes that are output (Click here).

      HINT:
      Even if the malfunction symptom is not confirmed, check the DTCs. This is because the system stores past DTCs.

    2. Clear the DTCs (Click here).

    3. Recheck for DTCs by simulating the operation indicated by the DTCs (Click here).
      Result 
      Result
      Proceed to
      DTC is output again
      A
      DTC is not output
      B



    B.
    Go to step 6
    A


    5.DIAGNOSTIC TROUBLE CODE CHART
    1. Find the output code in the Diagnostic Trouble Code Chart (Click here).


    NEXT

    Go to step 8


    6.PROBLEM SYMPTOMS TABLE
    1. Refer to the Problem Symptoms Table (Click here).
      Result 
      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table
      A
      Fault is listed in Problem Symptoms Table
      B



    B.
    ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE
    A


    7.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. Terminals of ECU (Click here).


    NEXT


    8.ADJUST, REPAIR OR REPLACE

      NEXT


      9.CONFIRMATION TEST

        NEXT

        END