STEERING ANGLE SENSOR > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD |
| 3. REMOVE LOWER NO. 3 STEERING WHEEL COVER |
![]() |
Using a screwdriver, detach the claw and guide and remove the lower No. 3 steering wheel cover.
| *1 | Protective Tape |
| 4. REMOVE LOWER NO. 2 STEERING WHEEL COVER |
![]() |
Using a screwdriver, detach the claw and guide and remove the lower No. 2 steering wheel cover.
| *1 | Protective Tape |
| 5. REMOVE STEERING PAD |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.
Pull the steering pad toward you.
![]() |
Disconnect the horn connector from the steering pad.
Using a screwdriver, release the 2 airbag connector locks.
| *1 | Protective Tape |
Disconnect the 2 airbag connectors to remove the steering pad as shown in the illustration.
| 6. REMOVE STEERING WHEEL ASSEMBLY |
![]() |
Disconnect the 2 connectors from the spiral cable.
Remove the steering wheel set nut.
![]() |
Put matchmarks on the steering wheel and main shaft.
| *a | Matchmark |
| *b | Hold |
| *c | Turn |
Using SST, remove the steering wheel.
| 7. REMOVE LOWER STEERING COLUMN COVER |
![]() |
Remove the 2 screws.
Detach the 2 claws to remove the lower steering column cover.
| 8. REMOVE UPPER STEERING COLUMN COVER |
Detach the 4 clips.
![]() |
Detach the claw to remove the upper steering column cover.
| 9. REMOVE SPIRAL CABLE SUB-ASSEMBLY |
![]() |
Disconnect the all connectors from the spiral cable with steering sensor.
Detach the 3 claws and remove the spiral cable with steering sensor.
| 10. REMOVE STEERING ANGLE SENSOR |
![]() |
Detach the 6 claws and remove the sensor.