Home › Vehicle Exterior › WINDOW / GLASS › QUARTER WINDOW GLASS

QUARTER WINDOW GLASS > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE ROOF HEADLINING ASSEMBLY (w/o Rear Seat Entertainment System)
  1. Remove the roof headlining assembly .



3. REMOVE ROOF HEADLINING (w/ Rear Seat Entertainment System)
  1. Remove the roof headlining assembly .



4. REMOVE ROOF HEADLINING (w/ Sliding Roof)
  1. Remove the roof headlining assembly .



5. REMOVE ROOF SIDE RAIL GARNISH ASSEMBLY


    B194339
  1. Detach the 4 clips and remove the roof side rail garnish.



6. REMOVE QUARTER WINDOW GLASS


B194340E01
  1. Apply protective tape to the outer circumference of the quarter window, as shown in the illustration.

  1. From the interior, insert piano wires between the vehicle body and quarter window, as shown in the illustration.

  1. Tie objects that can serve as handles (for example, wooden blocks) to all wire ends.

    NOTICE:
    When separating the quarter window glass from the vehicle, be careful not to damage the vehicle paint or interior/exterior ornaments.

  1. Cut through the adhesive by pulling the piano wire around the quarter window.