DTC P1340 Camshaft Position Sensor "A" (Bank 1 Sensor 2) |
DTC P1342 Camshaft Position Sensor "A" Low Input (MRE) |
DTC P1343 Camshaft Position Sensor "A" High Input (MRE) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P1340 | No camshaft position sensor signal to ECM during cranking (2 trip detection logic) |
|
| No camshaft position sensor signal to ECM with engine speed 600 rpm or more | ||
| P1342 | Output voltage of camshaft position sensor less than 0.3 V for 4 seconds (1 trip detection logic) | |
| P1343 | Output voltage of camshaft position sensor more than 4.7 V for 4 seconds (1 trip detection logic) |

| 1.INSPECT CAMSHAFT POSITION SENSOR (SENSOR POWER SOURCE) |
![]() |
Disconnect the camshaft position sensor connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D2-3 (VC) - Body ground | Ignition switch ON | 4.5 to 5.0 V |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (ECM - CAMSHAFT POSITION SENSOR) |
![]() |
Disconnect the camshaft position sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D2-1 (G2) - D56-90 (G2) | Always | Below 1 Ω |
| D2-2 (G-) - D56-89 (G2-) | Always | Below 1 Ω |
| D2-1 (G2) or D56-90 (G2) - Body ground | Always | 10 kΩ or higher |
| D2-2 (G-) or D56-89 (G2-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK SENSOR INSTALLATION |
![]() |
Check the camshaft position sensor installation.
|
| ||||
| OK | |
| 4.INSPECT CAMSHAFT TIMING PLATE (SIGNAL PLATE TOOTH) |
Check the teeth of the signal plate.
|
| ||||
| OK | |
| 5.REPLACE CAMSHAFT POSITION SENSOR |
Replace the camshaft position sensor (Click here).
| NEXT | |
| 6.CHECK WHETHER DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Clear DTCs (Click here).
Start the engine.
Enter the following menus: Powertrain / Engine and ECT / DTC / Pending.
Read DTCs.
| Result | Proceed to |
| No DTC is output | A |
| P1340, P1342 and/or P1343 are output | B |
|
| ||||
| A | ||
| ||