POWER WINDOW CONTROL SYSTEM > Rear Power Window LH does not Operate with Rear Power Window Switch LH |

| 1.CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY LH - BATTERY) |
![]() |
Disconnect the N9 rear power window regulator switch LH connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| N9-3 (B) - Body ground | Ignition switch ON | 11 to 14 V |
|
| ||||
| OK | |
| 2.INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY LH |
![]() |
Remove the rear power window regulator switch LH (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 4 (U) - 3 (B) | UP | Below 1 Ω |
| 1 (D) - 2 (SD) | UP | Below 1 Ω |
| 4 (U) - 5 (SU) | OFF | Below 1 Ω |
| 1 (D) - 2 (SD) | OFF | Below 1 Ω |
| 4 (U) - 5 (SU) | DOWN | Below 1 Ω |
| 1 (D) - 3 (B) | DOWN | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW SWITCH LH - REAR POWER WINDOW MOTOR LH) |
![]() |
Disconnect the N9 rear power window regulator switch LH connector.
Disconnect the N10 rear power window regulator motor LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| N9-1 (D) - N10-1 | Always | Below 1 Ω |
| N9-4 (U) - N10-2 | Always | Below 1 Ω |
| N9-1 (D) - Body ground | Always | 10 kΩ or higher |
| N9-4 (U) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.INSPECT REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH |
![]() |
Remove the rear power window regulator motor LH (Click here).
Apply battery voltage and check that the motor gear rotates smoothly as follows.
| Measurement Condition | Specified Condition |
| Battery positive (+) → 1 Battery negative (-) → 2 | Motor gear rotates counterclockwise |
| Battery positive (+) → 2 Battery negative (-) → 1 | Motor gear rotates clockwise |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (POWER WINDOW MASTER SWITCH - REAR POWER WINDOW SWITCH LH) |
![]() |
Disconnect the M2 power window regulator master switch connector.
Disconnect the N9 rear power window regulator switch LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| M2-12 (U) - N9-5 (SU) | Always | Below 1 Ω |
| M2-15 (D) - N9-2 (SD) | Always | Below 1 Ω |
| M2-12 (U) - Body ground | Always | 10 kΩ or higher |
| M2-15 (D) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||