ENGINE IMMOBILISER SYSTEM > Engine does not Start because No Initial Combustion |

| 1.CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 2.CHECK FOR DTC |
Check for DTCs (Click here).
| Result | Proceed to |
| DTCs are not output | A |
| DTCs are output | B |
|
| ||||
| A | |
| 3.READ VALUE USING GTS (IMMOBILISER FUEL CUT) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item / Range | Normal Condition | Diagnostic Note |
| Immobiliser Fuel Cut | Status of immobiliser system fuel cut / OFF/ON | ON: Immobiliser fuel cut on OFF: Immobiliser fuel cut off | - |
|
| ||||
| OK | ||
| ||
| 4.CHECK SECURITY INDICATOR LIGHT OPERATION |
Check that the security indicator light turns off when a registered key is inserted into the ignition key cylinder.
|
| ||||
| OK | ||
| ||
| 5.CHECK SECURITY INDICATOR LIGHT OPERATION |
Check that the security indicator light turns off when another registered key is inserted into the ignition key cylinder.
|
| ||||
| OK | |
| 6.CHECK WHETHER ENGINE STARTS |
Using another registered key, turn the ignition switch to ON.
Check that the engine starts 5 seconds after the ignition switch was turned to ON.
| Result | Proceed to |
| Engine can be started | A |
| Engine cannot be started | B |
|
| ||||
| A | |
| 7.REPLACE KEY |
Replace the key.
| NEXT | |
| 8.CHECK WHETHER ENGINE STARTS |
Using a registered key, turn the ignition switch to ON.
Check that the engine starts 5 seconds after the ignition switch was turned to ON.
| Result | Proceed to |
| Engine can be started | A |
| Engine cannot be started | B |
|
| ||||
| A | ||
| ||
| 9.REPLACE TRANSPONDER KEY COIL |
Temporarily replace the transponder key coil with a new or known good one (Click here).
| NEXT | |
| 10.CHECK WHETHER ENGINE STARTS |
Using a registered key, turn the ignition switch to ON.
Check that the engine starts 5 seconds after the ignition switch was turned to ON.
| Result | Proceed to |
| Engine can be started | A |
| Engine cannot be started | B |
|
| ||||
| A | ||
| ||
| 11.REPLACE TRANSPONDER KEY ECU ASSEMBLY |
Replace the transponder key ECU assembly with a new one.
| NEXT | |
| 12.CHECK WHETHER ENGINE STARTS |
Using a registered key, turn the ignition switch to ON.
Check that the engine starts 5 seconds after the ignition switch was turned to ON.
| Result | Proceed to |
| Engine can be started | A |
| Engine cannot be started | B |
|
| ||||
| A | ||
| ||
| 13.REPLACE KEY |
Temporarily replace the key with a new or known good one.
| NEXT | |
| 14.CHECK WHETHER ENGINE STARTS |
Using a registered key, turn the ignition switch to ON.
Check that the engine starts 5 seconds after the ignition switch was turned to ON.
| Result | Proceed to |
| Engine can be started | A |
| Engine cannot be started | B |
|
| ||||
| A | ||
| ||