OCCUPANT CLASSIFICATION SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
Confirm customer problem symptoms (Click here).
| |||||
| 3.PASSENGER AIRBAG ON/OFF INDICATOR CHECK |
| |||||
| 4.CHECK FOR DTC (Present and Past DTC)* |
Check for DTCs and note any codes that are output (Click here).
Check for DTCs (Click here).
Recheck for DTCs (Click here). Based on the DTCs output above, try to force output of the same CAN communication system DTC or occupant classification system DTC by simulating the symptoms indicated by the DTC.
| Result | Proceed to |
| DTC is output | A |
| DTC is not output | B |
|
| ||||
| |||||
| 5.DTC CHART |
| |||||
| 6.CIRCUIT INSPECTION* |
| |||||
| 7.REPAIR |
| |||||
| 8.CLEAR THE DTC (Present and Past DTCs)* |
Clear the DTCs (Click here).
| |||||
| 9.CHECK FOR DTCs (Present and Past DTC)* |
Check for DTCs Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| |||||
| 10.SYMPTOM SIMULATION |
Check the passenger airbag ON/OFF indicator condition (Click here).
| Result | Proceed to |
| Passenger airbag ON/OFF indicator operates normally | A |
| Passenger airbag ON/OFF indicator ("OFF") and SRS warning light come on | B |
|
| ||||
| |||||
| 11.CONFIRMATION TEST* |
|
| ||||
|---|---|---|---|---|---|