NAVIGATION SYSTEM > Steering Pad Switch Circuit |

| 1.INSPECT STEERING PAD SWITCH ASSEMBLY |
Remove the steering pad switch assembly (Click here).
Inspect the steering pad switch assembly (Click here).
|
| ||||
| OK | |
| 2.INSPECT SPIRAL CABLE SUB-ASSEMBLY |
Remove the spiral cable sub-assembly (Click here).
Inspect the spiral cable sub-assembly (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - SPIRAL CABLE SUB-ASSEMBLY) |
Disconnect the I53 navigation receiver assembly connector.
Disconnect the H54 spiral cable sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I53-21 (SW1) - H54-6 (AU1) | Always | Below 1 Ω |
| I53-22 (SW2) - H54-5 (AU2) | Always | Below 1 Ω |
| I53-23 (SWG) - H54-4 (EAU) | Always | Below 1 Ω |
| I53-21 (SW1) - Body ground | Always | 10 kΩ or higher |
| I53-22 (SW2) - Body ground | Always | 10 kΩ or higher |
| I53-23 (SWG) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||