Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio Receiver Type)

AUDIO AND VISUAL SYSTEM (for Radio Receiver Type) > Illumination Circuit

for Preparation Click here


DESCRIPTION

Power is supplied to the radio receiver assembly when the light control switch is in the tail or head position.

WIRING DIAGRAM


E303442E01


INSPECTION PROCEDURE

1.CHECK ILLUMINATION
  1. Check if the illumination for the radio receiver assembly or others (hazard switch etc.) comes on when the turn signal switch is turned to the head or tail position.
    Result 
    Result
    Proceed to
    Illumination comes on for all components except radio receiver assembly.
    A
    No illumination comes on (radio receiver assembly hazard switch etc.).
    B



B
GO TO LIGHTING SYSTEM (Click here)
A


2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - BATTERY AND COMBINATION METER ASSEMBLY)
  1. Disconnect the I1 and I2 radio receiver assembly connectors.

  1. Disconnect the H37 combination meter assembly connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    I1-10 (ILL+) - Body ground
    Light control switch in tail or head position
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I2-5 (ILL-) - H37-37 (ILL-)
    Always
    Below 1 Ω
    I2-5 (ILL-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)