Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio Receiver Type)

AUDIO AND VISUAL SYSTEM (for Radio Receiver Type) > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected areas below.


Audio Function 
Symptom
Suspected Area
See page
Pressing power switch does not turn on system.
Proceed to "Pressing Power Switch does not Turn on System"
Click here
Proceed to "Radio Receiver Power Source Circuit"
Click here
Radio receiver assembly
Click here
No sound can be heard from speakers (Audio is mute.).
Proceed to "Radio Receiver Power Source Circuit"
Click here
Proceed to "No Sound can be Heard from Speakers"
Click here
Proceed to "Speaker Circuit (Built-in Amplifier)"
Click here
Radio receiver assembly
Click here
Sound quality is bad in all modes (Volume is too low.).
Proceed to "Poor Sound Quality in All Modes (Low Volume)"
Click here
Proceed to "Speaker Circuit (Built-in Amplifier)"
Click here
Radio receiver assembly
Click here
ASL does not function.
Proceed to "Vehicle Speed Signal Circuit between Radio Receiver and Combination Meter"
Click here
External device sound cannot be heard or sound quality is bad (Stereo jack is used.).
Proceed to "Radio Receiver Power Source Circuit"
Click here
Proceed to "Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter"
Click here
No. 1 stereo jack adapter assembly
Click here
Radio receiver assembly
Click here
Abnormal noise occurs.
Proceed to "Noise Occurs"
Click here
Radio receiver assembly
Click here
Radio broadcast cannot be received or poor reception.
Proceed to "Radio Broadcast cannot be Received (Poor Reception)"
Click here
CD cannot be inserted/played or CD is ejected right after insertion.
Proceed to "Radio Receiver Power Source Circuit"
Click here
Proceed to "CD cannot be Inserted/Played or CD is Ejected Right After Insertion"
Click here
CD cannot be ejected.
Proceed to "Radio Receiver Power Source Circuit"
Click here
Proceed to "CD cannot be Ejected"
Click here
Sound quality is bad only when CD is played (Volume is too low.).
Proceed to "Sound Quality is Bad Only when CD is Played (Volume is Too Low)"
Click here
CD sound skips.
Proceed to "CD Sound Skips"
Click here
Radio receiver cannot be illuminated at night.
Proceed to "Illumination Circuit"
Click here
Radio receiver assembly
Click here