AUDIO AND VISUAL SYSTEM > Steering Pad Switch Circuit |

| 1.CHECK RADIO RECEIVER ASSEMBLY |
![]() |
Disconnect the I3 radio receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| I3-7 (SW1) - I3-6 (SWG) | No switch is pushed | 100 kΩ or higher |
| Seek+ switch: push | Below 1 Ω | |
| Seek- switch: push | 312 to 345 Ω | |
| Volume+ switch: push | 950 to 1050 Ω | |
| Volume- switch: push | 2954 to 3265 Ω | |
| I3-8 (SW2) - I3-6 (SWG) | No switch is pushed | 100 kΩ or higher |
| MODE switch: push | Below 1 Ω |
|
| ||||
| OK | ||
| ||
| 2.INSPECT STEERING PAD SWITCH ASSEMBLY |
Remove the steering pad switch assembly (Click here).

Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 10 (AU1) - 8 (EAU) | No switch is pushed | 100 kΩ or higher |
| Seek+ switch: push | Below 1 Ω | |
| Seek- switch: push | 312 to 345 Ω | |
| Volume+ switch: push | 950 to 1050 Ω | |
| Volume- switch: push | 2954 to 3265 Ω | |
| 9 (AU2) - 8 (EAU) | No switch is pushed | 100 kΩ or higher |
| MODE switch: push | Below 1 Ω |
|
| ||||
| OK | |
| 3.INSPECT SPIRAL CABLE |
![]() |
Remove the spiral cable (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 8 (EAU) - 4 (EAU) | Spiral cable is turned 2.5 rotations counterclockwise | Below 1 Ω |
| Spiral cable is centered | ||
| Spiral cable is turned 2.5 rotations clockwise | ||
| 10 (AU1) - 6 (AU1) | Spiral cable is turned 2.5 rotations counterclockwise | |
| Spiral cable is centered | ||
| Spiral cable is turned 2.5 rotations clockwise | ||
| 9 (AU2) - 5 (AU2) | Spiral cable is turned 2.5 rotations counterclockwise | |
| Spiral cable is centered | ||
| Spiral cable is turned 2.5 rotations clockwise |
|
| ||||
| OK | ||
| ||