STEERING WHEEL > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE LOWER NO. 3 STEERING WHEEL COVER |
![]() |
Using a screwdriver, detach the 2 claws and remove the steering wheel cover.
| 3. REMOVE LOWER NO. 2 STEERING WHEEL COVER |
![]() |
Using a screwdriver, detach the 2 claws and remove the steering wheel cover.
| 4. REMOVE STEERING PAD |
![]() |
Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.
Pull the steering pad toward you.
![]() |
Using a thin-bladed screwdriver, release the locking button.
Using a thin-bladed screwdriver, disconnect the 2 connectors.
Disconnect the horn connector.
| 5. REMOVE STEERING WHEEL ASSEMBLY |
![]() |
Detach the cruise control main wire harness clamp from the steering wheel side.
Disconnect the steering pad switch connector and cruise control main switch connector from the spiral cable.
Remove the steering wheel set nut.
![]() |
Put matchmarks on the steering wheel and main shaft.
Using SST, remove the steering wheel.
| 6. REMOVE STEERING PAD SWITCH ASSEMBLY (w/ Steering Pad Switch) |
![]() |
Disconnect the connector.
Remove the 2 screws.
Detach the 4 pins and remove the steering pad switch.
| 7. REMOVE STEERING PAD COVER RH (w/o Steering Pad Switch) |
![]() |
Remove a screw.
Detach the 2 pins and remove the steering pad cover.
| 8. REMOVE STEERING PAD COVER LH (w/o Steering Pad Switch) |
![]() |
Remove a screw.
Detach the 2 pins and remove the steering pad cover.
| 9. REMOVE CRUISE CONTROL MAIN SWITCH |
![]() |
Remove the 2 screws and remove the cruise control main switch.
| 10. REMOVE STEERING WHEEL PAD ATTACHING SCREW |
![]() |
Remove the 2 steering wheel pad attaching screws.