Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio and Display Type)

AUDIO AND VISUAL SYSTEM (for Radio and Display Type) > Radio Broadcast cannot be Received (Bad Reception)

for Preparation Click here


WIRING DIAGRAM


E278320E12


INSPECTION PROCEDURE

1.CHECK IF RADIO AUTO-SEARCH FUNCTIONS PROPERLY
  1. Check the radio automatic station search function by activating it.

    OK:
    Automatic station search function stops on a station.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.CHECK OPTIONAL COMPONENTS
  1. Check if any optional components that may decrease reception capacity, such as sunshade film or a telephone antenna, are installed.

    OK:
    Optional components are installed.

    NOTICE:
    Do not remove optional components without permission of the customer.



NG
Go to step 3
OK

REMOVE OPTIONAL COMPONENTS AND CHECK AGAIN (SEE NOTICE ABOVE) 

3.INSPECT QUARTER WINDOW GLASS (WINDOW GLASS ANTENNA WIRE)
  1. Inspect the quarter window glass (window glass antenna wire) (Click here).



NG
REPAIR QUARTER WINDOW GLASS (WINDOW GLASS ANTENNA WIRE) (Click here)
OK


4.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY (ANTENNA)


    E276819
  1. Remove the antenna connector from the radio and display receiver assembly.

  1. Turn the ignition switch to ACC with the radio and display receiver assembly connector connected.

  1. Turn on the radio and turn into AM mode.

  1. Place a screwdriver, thin wire or other metal object on the radio and display receiver assembly antenna jack and check that noise can be heard from the speakers.

    OK:
    Noise occurs.



NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)
OK


5.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY


    E277921E01
  1. Disconnect the RA radio and display receiver assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    5 (ANT+) - Body ground
    Ignition switch ACC, radio switch on and FM or AM selected
    11 to 14 V



NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)
OK


6.CHECK ANTENNA CORD SUB-ASSEMBLY


    E299664E01
  1. Disconnect the radio and display receiver assembly connector.

  1. Disconnect the antenna connector from the amplifier antenna assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    RA-3 (MAIN) - 3
    Always
    Below 1 Ω
    RA-5 (ANT+) - 1
    Always
    Below 1 Ω
    RA-3 (MAIN) - Body ground
    Always
    10 kΩ or higher
    RA-5 (ANT+) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Radio and Display Receiver Assembly)
    *b
    Front view of wire harness connector
    (to Amplifier Antenna Assembly)



NG
REPLACE ANTENNA CORD SUB-ASSEMBLY
OK


7.CHECK AMPLIFIER ANTENNA ASSEMBLY
  1. Replace the amplifier antenna assembly and check if radio broadcasts can be received normally.

    OK:
    Radio broadcasts can be received normally.



NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)
OK

END (AMPLIFIER ANTENNA ASSEMBLY IS DEFECTIVE)