Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SEAT POSITION SENSOR

SEAT POSITION SENSOR > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

HINT:
Installation is in the reverse order of removal.
The procedure described below is for the LH side.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT SEAT ASSEMBLY LH (for Manual Seat)
  1. Remove the front seat assembly (Click here).



4. REMOVE FRONT SEAT ASSEMBLY LH (for Power Seat)
  1. Remove the front seat assembly (Click here).



5. REMOVE FRONT SEAT CUSHION SHIELD (for Manual Seat)


    B190973
  1. Remove the 2 hog rings and rubber bands of the seatback cover from the seat frame.



    B190974E01
  1. Remove the 3 screws.

  1. Detach 3 claws in the order shown in the illustration, and then remove the front seat cushion shield.

  1. Detach the wire harness clamp and disconnect the connector.



6. REMOVE SEAT POSITION AIRBAG SENSOR (for Manual Seat)


    B194811
  1. Disconnect the connector from the seat position airbag sensor.

  1. Using T30 "TORX" socket wrench, remove the screw and the seat position airbag sensor.

  1. Remove the seat slide position sensor protector from the seat position airbag sensor.



7. REMOVE SEAT POSITION AIRBAG SENSOR (for Power Seat)


    B194812
  1. Disconnect the connector from the seat position airbag sensor.

  1. Using "TORX" socket wrench T30, remove the "TORX" screw and the seat position airbag sensor.

  1. Remove the seat slide position sensor protector from the seat position airbag sensor.