DTC B1796 Sleep Operation Failure of Occupant Classification ECU |
| DTC Code | DTC Detection Condition | Trouble Area |
| B1796 | Occupant classification ECU malfunction | Occupant classification ECU |
| 1.CHECK FOR DTCs |
Turn the ignition switch to ON, and wait for at least 60 seconds.
Clear any DTCs stored in the memory (Click here).
Turn the ignition switch off, and wait for at least 10 seconds.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Using the intelligent tester, check for DTCs of the occupant classification ECU (Click here).
|
| ||||
| OK | ||
| ||
| 2.REPLACE OCCUPANT CLASSIFICATION ECU |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Replace the occupant classification ECU (Click here).
| NEXT | |
| 3.PERFORM ZERO POINT CALIBRATION |
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Using the intelligent tester, perform the zero point calibration (Click here).
| NEXT | |
| 4.PERFORM SENSITIVITY CHECK |
Using the intelligent tester, perform the sensitivity check (Click here).
| NEXT | ||
| ||