Home › Drivetrain ยท DRIVE SHAFT / PROPELLER SHAFT › REAR DRIVE SHAFT ASSEMBLY

REAR DRIVE SHAFT ASSEMBLY > REMOVAL

for Preparation Click here



1. DRAIN REAR DIFFERENTIAL OIL
  1. Stop the vehicle on a level place.

  1. for Front Differential:

    1. Using a 10 mm hexagon wrench, remove the filler plug and gasket.

    2. Using a 10 mm hexagon wrench, remove the drain plug and gasket, and drain the oil.

    3. Using a 10 mm hexagon wrench, install a new gasket and the drain plug.

      Torque:
      39 N*m{ 400 kgf*cm , 29 ft.*lbf }

  1. for Rear Differential:

    1. Using a 10 mm hexagon wrench, remove the filler plug and gasket.

    2. Using a 10 mm hexagon wrench, remove the drain plug and gasket, and drain the oil.

    3. Using a 10 mm hexagon wrench, install a new gasket and the drain plug.

      Torque:
      65 N*m{ 660 kgf*cm , 48 ft.*lbf }



2. REMOVE REAR AXLE CARRIER ASSEMBLY
  1. Remove the rear axle carrier assembly (Click here).



3. REMOVE REAR DRIVE SHAFT ASSEMBLY


    C179278E01
  1. Using SST, remove the rear drive shaft assembly.

    SST
    09520-01010  
    09520-24010   (09520-32040)

    NOTICE:
    Be careful not to damage the differential oil seal, inboard joint boot and drive shaft dust cover.