REAR AXLE CARRIER > REMOVAL |
| 1. REMOVE REAR COIL SPRING LH (for Rear Coil Spring Type) |
Remove the coil spring (Click here).
| 2. REMOVE REAR PNEUMATIC CYLINDER ASSEMBLY LH (for Pneumatic Cylinder Type) |
Remove the pneumatic cylinder assembly (Click here).
| 3. REMOVE PARKING BRAKE ASSEMBLY |
Remove the parking brake assembly (Click here).
| 4. REMOVE REAR SPEED SENSOR LH |
![]() |
Disconnect the rear speed sensor connector.
Using a hexagon wrench, remove the bolt and the rear speed sensor.
| 5. REMOVE REAR HUB GREASE CAP LH |
![]() |
Using a screwdriver and hammer, remove the axle hub grease cap.
| 6. REMOVE REAR AXLE SHAFT NUT LH |
![]() |
Remove the cotter pin and adjusting lock cap.
Using a 39 mm socket wrench, remove the axle hub nut.
| 7. SEPARATE NO. 2 REAR SUSPENSION ARM ASSEMBLY LH |
![]() |
Remove the cotter pin and nut.
![]() |
Using SST, separate the No. 2 rear suspension arm.
| 8. REMOVE REAR AXLE ASSEMBLY |
![]() |
Put matchmarks on the No. 1 rear suspension arm and adjust cam.
Remove the 2 bolts and nut.
Using a plastic-faced hammer, tap out the front drive shaft from the rear axle carrier sub-assembly LH.
| 9. REMOVE REAR AXLE CARRIER LH |
![]() |
Remove the 4 bolts and axle hub and bearing from the rear axle carrier.
![]() |
Remove the O-ring from rear axle hub.
| 10. REMOVE REAR AXLE HUB DUST SEAL LH |
![]() |
Using a screwdriver and hammer, remove the bearing dust deflector from the rear axle carrier.