Home › Drivetrain ยท AXLE AND DIFFERENTIAL › REAR AXLE HUB

REAR AXLE HUB > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The procedure listed below is for the LH side.



1. REMOVE REAR COIL SPRING LH (for Rear Coil Spring Type)
  1. Remove the coil spring (Click here).



2. REMOVE REAR PNEUMATIC CYLINDER ASSEMBLY LH (for Pneumatic Cylinder Type)
  1. Remove the pneumatic cylinder assembly (Click here).



3. REMOVE PARKING BRAKE ASSEMBLY
  1. Remove the parking brake assembly (Click here).



4. REMOVE REAR SPEED SENSOR LH


    C178153
  1. Disconnect the rear speed sensor connector.

  1. Using a hexagon wrench, remove the bolt and the rear speed sensor.



5. REMOVE REAR HUB GREASE CAP LH


    C180977
  1. Using a screwdriver and hammer, remove the axle hub grease cap.

    NOTICE:
    Do not damage the axle hub.



6. REMOVE REAR AXLE SHAFT NUT LH


    C180976
  1. Remove the cotter pin and adjusting lock cap.

  1. Using a 39 mm socket wrench, remove the axle hub nut.



7. SEPARATE NO. 2 REAR SUSPENSION ARM ASSEMBLY LH


    C180775
  1. Remove the cotter pin and nut.



    C181305E01
  1. Using SST, separate the No. 2 rear suspension arm.

    SST
    09950-40011   (09951-04010, 09953-04020, 09954-04010, 09955-04031, 09958-04011, 09952-04010)
    09955-04090  

    HINT:
    1. Claw A 09955-04090
    2. Claw B 09955-04031



8. REMOVE REAR AXLE ASSEMBLY


    C180987E01
  1. Put matchmarks on the No. 1 rear suspension arm and adjust cam.

  1. Remove the 2 bolts and nut.

  1. Using a plastic-faced hammer, tap out the front drive shaft from the rear axle carrier sub-assembly LH.

    NOTICE:
    Be careful not to damage the drive shaft boot.



9. REMOVE REAR AXLE CARRIER LH


    C180975
  1. Remove the 4 bolts and axle hub and bearing from the rear axle carrier.



    C180968
  1. Remove the O-ring from rear axle hub.