Home › Drivetrain ยท AXLE AND DIFFERENTIAL › REAR DIFFERENTIAL CARRIER ASSEMBLY

REAR DIFFERENTIAL CARRIER ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY
  1. Using a jack, slowly raise the rear differential carrier assembly to its installation position.



    C180988E02
  1. Temporarily install the 6 bolts.

  1. Tighten the 4 bolts in order, from A to D.

    Torque:
    120 N*m{ 1224 kgf*cm , 89 ft.*lbf }

    Using hexagon wrench, tighten the 2 bolts order, E to F.

    Torque:
    200 N*m{ 2039 kgf*cm , 148 ft.*lbf }



2. INSTALL REAR DRIVE SHAFT ASSEMBLY LH
  1. Install the drive shaft assembly (Click here).



3. INSTALL REAR DRIVE SHAFT ASSEMBLY RH

HINT:
Use the same procedure as the LH side.



4. INSTALL PROPELLER SHAFT ASSEMBLY
  1. Install the propeller shaft assembly (Click here).



5. ADD DIFFERENTIAL OIL


    D025304E27
  1. Add differential oil so that the oil level is between 0 to 5 mm (0 to 0.197 in.) from the bottom lip of the differential filler plug hole.

    NOTICE:
    1. Too much or too little oil will lead to differential problems.
    2. After changing the oil, drive the vehicle and then check the oil level again.

    Oil Type:
    Item
    Oil Type and Viscosity
    Front differential
    Toyota Genuine Differential gear oil LT 75W-85 GL-5 or equivalent.
    Rear differential

    Front Differential Capacity:
    Specified Condition
    2.00 to 2.10 liters (2.1 to 2.2US qts., 1.7 to 1.8 Imp. qts.)

    Rear Differential Capacity:
    Specified Condition
    1.50 to 1.60 liters (1.6 to 1.7 US qts., 1.3 to 1.4 Imp. qts.)

  1. for Rear Differential:

    1. Using a 10 mm hexagon wrench, install a new gasket and the filler plug.

      Torque:
      39 N*m{ 400 kgf*cm , 29 ft.*lbf }

  1. for Front Differential:

    1. Using a 10 mm hexagon wrench, install a new gasket and the filler plug.

      Torque:
      39 N*m{ 400 kgf*cm , 29 ft.*lbf }