FRONT DIFFERENTIAL CARRIER ASSEMBLY (for 4WD) > INSTALLATION |
| 1. INSTALL FRONT DIFFERENTIAL CARRIER ASSEMBLY |
![]() |
Install the differential support with the F and G bolts.
Using a jack, slowly raise the front differential carrier assembly to its installation position.
Temporarily install the A, B, C, D and E bolts.
Tighten the A bolt.
Tighten the B and C bolts.
Tighten the D and E bolts.
Connect the automatic disconnecting differential actuator hose.
Connect the automatic disconnecting differential actuator connector.
| 2. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH |
Install the front drive shaft (Click here).
| 3. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH |
| 4. INSTALL FRONT PROPELLER SHAFT ASSEMBLY |
Install the front propeller shaft (Click here).
| 5. ADD DIFFERENTIAL OIL |
![]() |
Add differential oil so that the oil level is between 0 to 5 mm (0 to 0.197 in.) from the bottom lip of the differential filler plug hole.
| Item | Oil Type and Viscosity |
| Front differential | Toyota Genuine Differential gear oil LT 75W-85 GL-5 or equivalent. |
| Rear differential |
| Specified Condition | |
| 2.00 to 2.10 liters (2.1 to 2.2US qts., 1.7 to 1.8 Imp. qts.) |
| Specified Condition | |
| 1.50 to 1.60 liters (1.6 to 1.7 US qts., 1.3 to 1.4 Imp. qts.) |
for Rear Differential:
Using a 10 mm hexagon wrench, install a new gasket and the filler plug.
for Front Differential:
Using a 10 mm hexagon wrench, install a new gasket and the filler plug.
| 6. INSTALL NO. 1 ENGINE UNDER COVER |
![]() |
Hook the engine under cover to the vehicle body as shown in the illustration.
Install the 3 screws and 5 bolts.
| 7. INSTALL FRONT WHEEL |
Install the front wheels.
| 8. INSPECT AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR |
Inspect the automatic disconnecting differential actuator .