Home › Drivetrain ยท AXLE AND DIFFERENTIAL › REAR DIFFERENTIAL CARRIER ASSEMBLY

REAR DIFFERENTIAL CARRIER ASSEMBLY > REMOVAL

for Preparation Click here



1. DRAIN DIFFERENTIAL OIL
  1. Stop the vehicle on a level place.

  1. for Front Differential:

    1. Using a 10 mm hexagon wrench, remove the filler plug and gasket.

    2. Using a 10 mm hexagon wrench, remove the drain plug and gasket, and drain the oil.

    3. Using a 10 mm hexagon wrench, install a new gasket and the drain plug.

      Torque:
      39 N*m{ 400 kgf*cm , 29 ft.*lbf }

  1. for Rear Differential:

    1. Using a 10 mm hexagon wrench, remove the filler plug and gasket.

    2. Using a 10 mm hexagon wrench, remove the drain plug and gasket, and drain the oil.

    3. Using a 10 mm hexagon wrench, install a new gasket and the drain plug.

      Torque:
      65 N*m{ 660 kgf*cm , 48 ft.*lbf }



2. REMOVE PROPELLER SHAFT ASSEMBLY
  1. Remove the propeller shaft assembly (Click here).



3. REMOVE REAR DRIVE SHAFT ASSEMBLY LH
  1. Remove the drive shaft assembly (Click here).



4. REMOVE REAR DRIVE SHAFT ASSEMBLY RH

HINT:
Use the same procedure as the LH side.



5. REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY


    C180988
  1. Remove the bolt and rear differential carrier assembly.

  1. Support the rear differential with a jack.

  1. Slowly lower the jack, and remove the rear differential carrier.