Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio and Display Type)

AUDIO AND VISUAL SYSTEM (for Radio and Display Type) > AVC-LAN Circuit

for Preparation Click here


DESCRIPTION

Each unit of the audio system connected to the AVC-LAN (communication bus) transfers the signal of each switch by communication.
When a short to +B or short to ground occurs in this AVC-LAN, the audio system will not function normally as the communication is discontinued.

WIRING DIAGRAM


E283617E01


INSPECTION PROCEDURE

1.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY


    E283610E01
  1. Remove the radio and display receiver assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    9 (TXM+) - 10 (TXM-)
    Always
    60 to 80 Ω



NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - TELEVISION DISPLAY ASSEMBLY)
  1. Disconnect the I57 radio and display receiver assembly connector.

  1. Disconnect the U13 television display assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I57-9 (TXM+) - U13- 3 (TX1+)
    Always
    Below 1 Ω
    I57-10 (TXM-) - U13- 4 (TX1-)
    Always
    Below 1 Ω
    I57-9 (TXM+) - Body ground
    Always
    10 kΩ or higher
    I57-10 (TXM-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK TELEVISION DISPLAY ASSEMBLY
  1. Replace the television display assembly with a known good one (Click here).

  1. Check the rear seat entertainment system (Click here).

    OK:
    Malfunction disappears.



NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)
OK

END (TELEVISION DISPLAY ASSEMBLY IS DEFECTIVE)