Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR

REAR SPEED SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL REAR SPEED SENSOR LH


C178153
  1. Using a hexagon wrench, install the rear speed sensor with the bolt.

    Torque:
    8.3 N*m{ 85 kgf*cm , 73 in.*lbf }

    NOTICE:
    1. Make sure that there are no pieces of iron or other foreign matter attached to the sensor tip part.
    2. While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip part.
    3. After installing the speed sensor, make sure that there is no clearance or foreign matter between the sensor stay part and the knuckle.
    4. Make sure that there is no foreign matter attached to the magnetic rotor.

  1. Connect the rear speed sensor connector.



2. INSTALL REAR WHEEL

Torque:
131 N*m{ 1336 kgf*cm , 97 ft.*lbf }



3. CHECK SPEED SENSOR SIGNAL
  1. Check the speed sensor signal (Click here).