Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > FAIL-SAFE CHART

for Preparation Click here



FAIL SAFE OPERATION
  1. If there is a problem with sensor signals or actuator systems, the skid control ECU prohibits power supply to the VSC actuator and informs the ECM of VSC system failure.
    The VSC actuator turns off each solenoid and the ECM shuts off VSC control (traction control signal) from the skid control ECU. As a result, it is as if the ABS, TRC and VSC systems are not installed in the vehicle.
    The ABS control will be prohibited, but EBD control continues as much as possible. If EBD control is impossible, the brake warning light comes on to warn the driver (Click here).
  2. If system components have any malfunction before starting control, immediately stop the operation.
    If system components have any malfunction during control, gradually stop the control so as not to trigger a sudden change in vehicle conditions.
    If it is impossible to control the systems, the warning/indicator lights come on or blink to inform the driver of the termination of the systems (Click here).

HINT:
  1. If the ABS, BA, TRC and VSC systems encounter a malfunction, the brake system will operate normally without ABS, BA, TRC and VSC control.
  2. If there is a problem with the VSC actuator, brake performance will gradually decrease and control of the ABS, BA, TRC and VSC systems will be prohibited.

  1. ABS, EBD and BA system:

    Malfunction Area
    Control Method
    ABS system
    ABS, BA, TRC and VSC control is prohibited
    BA system
    ABS, BA, TRC and VSC control is prohibited
    EBD system
    ABS, EBD, BA, TRC and VSC control is prohibited

  2. TRC and VSC system:

    HINT:
    As for the TRC and VSC systems, different systems prohibit different controls according to the malfunctioning part.


    Malfunction Area
    Control Method
    Engine control system
    (TRC and VSC systems)
    Before control: Disables control
    During control: Uses only brakes to effect control
    Brake control system
    (VSC system)
    Before control: Disables control
    During control: Uses only engine to effect control
    Brake control system
    (TRC system)
    Brake control: Disables control
    During control: Disables control (by gradually ending control)


SYSTEM TEMPERATURE PROTECTION OPERATION
If the TRC system has been used constantly for a long time, the temperature of the brake pads may excessively increase. If the temperature increases even more, the indicator lights come on or blink.

System
Indicator Condition
TRC system
Slip indicator light comes on

HINT:
If the slip indicator light goes off, the systems automatically return to normal operating conditions. As this is not a malfunction, no DTC will be recorded.