Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SIDE AIRBAG SENSOR

SIDE AIRBAG SENSOR > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH


    B194240
  1. Detach the 3 clips and remove the front door lower frame bracket garnish.



4. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH (for 14 Speakers)


    B190538
  1. Detach the 3 clips and remove the front door lower frame bracket garnish.

  1. Disconnect the connector.



5. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG


    B190539
  1. Using a moulding remover, detach the 4 claws and remove the front door inside handle bezel plug.



6. REMOVE FRONT ARMREST BASE UPPER PANEL


    B190537
  1. Detach the 2 clips and 5 claws and remove the front armrest base upper panel.

  1. Disconnect the connector.



7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY


B190541
  1. Remove the front door armrest cover.

  1. Remove the 2 screws.



    B190542
  1. Detach the 10 clips.

  1. Disconnect the connector.



    B190543
  1. Disconnect the front door lock remote control cable and front door inside locking cable and remove the front door trim board sub-assembly.



8. REMOVE SIDE AIRBAG SENSOR ASSEMBLY

CAUTION:
Confirm that the cable is disconnected from the battery negative (-) terminal. Even an impact to only the airbag sensor will cause the airbag to deploy.



    B194500E01
  1. Slide the outer housing and disconnect the airbag connector.

  1. Remove the bolt.

  1. Detach the guide and remove the side airbag sensor.