DTC C1752 Height Control Compressor Motor Circuit Malfunction |
| DTC Code | Detection Condition | Trouble Area |
| C1752 | When either of the following is detected:
|
|

| 1.INSPECT SUSPENSION CONTROL RELAY (AIR SUS) |
Turn the ignition switch off.
![]() |
Remove the AIR SUS relay from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 5 | When 12 V battery voltage is not applied to terminal 1 and 2 | 10 kΩ or higher |
| When 12 V battery voltage is applied to terminal 1 and 2 | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (COMPRESSOR - ECU, BATTERY AND BODY GROUND) |

Remove the AIR SUS relay from the engine room relay block.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Relay block AIR SUS relay terminal 5 - Body ground | Always | 11 to 14 V |
Disconnect the Q7 compressor connector.
Disconnect the O17 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Relay block AIR SUS relay terminal 3 - Q7-1 (B) | Always | Below 1 Ω |
| Relay block AIR SUS relay terminal 3 or Q7-1 (B) - Body ground | Always | 10 kΩ or higher |
| Q7-2 (E) - Body ground | Always | Below 1 Ω |
| Q7-3 (RM+) - O17-19 (RM+) | Always | Below 1 Ω |
| Q7-3 (RM+) or O17-19 (RM+) - Body ground | Always | 10 kΩ or higher |
| Q7-4 (RM-) - O17-17 (RM-) | Always | Below 1 Ω |
| Q7-4 (RM-) or O17-17 (RM-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT NO. 1 HEIGHT CONTROL COMPRESSOR (COMPRESSOR MOTOR) |
![]() |
Apply 12 V battery voltage to the compressor motor and check the operation of the motor.
| Measurement Condition | Specified Value |
| 12 V battery positive (+) → Terminal 1 (B) 12 V battery negative (-) → Terminal 2 (E) | Motor operates |
|
| ||||
| OK | ||
| ||