Home › Suspension › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM (w/ AVS)

DTC    C1793    Height Control Off Switch Circuit

for Preparation Click here


DESCRIPTION

Height control can be operated or suspended by pressing the height control mode select switch.
By pressing the switch once, height control can be suspended.
By pressing the switch one more time, height control can be operated.

DTC Code
Detection Condition
Trouble Area
C1793
Height control mode select switch signal does not change.
  1. Height control mode select switch
  2. Wire harness or connector
  3. Suspension control ECU

HINT:
This DTC is output only when the sensor signal check is done.


WIRING DIAGRAM


C180264E01


INSPECTION PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER (MANUAL MODE SWITCH)
  1. Turn the ignition switch off.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON, and turn the intelligent tester on.

  1. Enter the following menus: Chassis / Air suspension / Data List.

    Air Suspension 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Manual Mode Switch
    Height control mode select switch (Manual)/ ON or OFF
    ON: Height control mode select switch ON condition
    OFF: Height control mode select switch OFF condition
    -

  1. Check that the value displayed on the intelligent tester changes by pressing the height control mode select switch.

    OK:
    Height control mode select switch value changes.

    Result 
    Result
    Proceed to
    NG
    A
    OK (When troubleshooting according to the Problem Symptoms Table)
    B
    OK (When troubleshooting according to the DTC Chart)
    C



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
USE SIMULATION METHOD TO CHECK (Click here)
A


2.INSPECT HEIGHT CONTROL MODE SELECT SWITCH
  1. Turn the ignition switch off.



    C179512E01
  1. Remove the height control mode select switch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 (E) - 6 (MSW)
    Free
    10 kΩ or higher
    3 (E) - 6 (MSW)
    Pushed in
    Below 1 Ω



NG
REPLACE HEIGHT CONTROL MODE SELECT SWITCH
OK


3.CHECK HARNESS AND CONNECTOR (HEIGHT CONTROL MODE SELECT SWITCH - ECU AND BODY GROUND)


    C180265E01
  1. Disconnect the O17 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H73-6 (MSW) - O17-24 (TD)
    Always
    Below 1 Ω
    H73-3 (E) - Body ground
    Always
    Below 1 Ω
    H73-6 (MSW) or O17-24 (TD) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SUSPENSION CONTROL ECU (Click here)