Home › Suspension › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM (w/ AVS)

DTC    C1781    Suspension Control ECU Malfunction

for Preparation Click here


DESCRIPTION

If a malfunction in the suspension control ECU is detected, DTC C1781 is output.

DTC Code
Detection Condition
Trouble Area
C1781
Suspension control ECU malfunction is detected
  1. Wire harness or connector
  2. Suspension control ECU

INSPECTION PROCEDURE

HINT:
  1. If DTC C1782 (ECU malfunction) is displayed, perform the inspection necessary for DTC C1782 first (Click here).
  2. If DTC U0122, U0100, U0126 and C1781 (Suspension Control ECU Malfunction) are output at the same time, perform the inspection necessary for the CAN communication system first.
  3. The suspension control ECU, controlling the air suspension system, is activated when the ignition switch is turned ON.
    After 2 seconds, the "MAIN RELAY" built in the ECU is activated and the system is driven by +B power source.
    Vehicle height may increase after turning the ignition switch off and unloading the vehicle/letting people get out of the vehicle. In order to adjust the vehicle height, vehicle height control will continue for a while from then.

1.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Perform a road test.

  1. Check for DTC (Click here).
    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE SUSPENSION CONTROL ECU (Click here)