Home › Suspension › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM (w/ AVS)

DTC    C1781    Suspension Control ECU Malfunction

for Preparation Click here


DESCRIPTION

If a malfunction in the suspension control ECU is detected, DTC C1781 is output.

DTC Code
Detection Condition
Trouble Area
C1781
Suspension control ECU malfunction is detected.
Suspension control ECU

INSPECTION PROCEDURE

NOTICE:
After replacing the suspension control ECU, perform registration (Click here).

HINT:
  1. If DTC C1782 (ECU malfunction) is displayed, perform the inspection necessary for DTC C1782 first (Click here).
  2. If DTC U0100, U0122, U0124, U0126, U0140 and C1781 (Suspension Control ECU Malfunction) are output at the same time, perform the inspection necessary for the CAN communication system first.
  3. The suspension control ECU, controlling the air suspension system, is activated when the ignition switch is turned to ON.
    After 2 seconds, the "MAIN RELAY" built into the ECU is activated and the system is driven by +B power source.
    Vehicle height may increase after turning the ignition switch off and unloading the vehicle/letting people get out of the vehicle. In order to adjust the vehicle height, vehicle height control will continue for a while from then.

1.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Perform a road test.

  1. Check for DTC (Click here).
    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE SUSPENSION CONTROL ECU (Click here)