Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Security Indicator Light Circuit

for Preparation Click here


DESCRIPTION

When the theft deterrent system is in the disarmed state, the security indicator will flash continuously if the immobiliser system is set, or not illuminate if the immobiliser system is not set.
When the theft deterrent system is in the armed state, the immobiliser system is automatically set and the security indicator will flash continuously.
When the theft deterrent system is in the arming preparation state and alarm sounding state, the main body ECU causes the security indicator to be illuminated.

WIRING DIAGRAM


B223955E01


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SECURITY INDICATOR)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester main switch on.

  1. Select the item below in the Active Test and then check that the indicator operates.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Security Indicator
    Security indicator
    ON/OFF
    -

    OK:
    The security indicator light flashes or goes off correctly when operating it through the intelligent tester.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (SECURITY INDICATOR - MAIN BODY ECU)


    B160794E02
  1. Disconnect the H1 main body ECU connector.

  1. Disconnect the I22 accessory meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H1-4 (IND) - I22-16 (MHTR)
    Always
    Below 1 Ω
    H1-4 (IND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (SECURITY INDICATOR - BODY GROUND)


    E146701E05
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I22-12 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.INSPECT ACCESSORY METER ASSEMBLY


    E146077E04
  1. Reconnect the I22 accessory meter connector with the H1 main body ECU connector still disconnected.

  1. Apply battery voltage from the wire harness back side between the specified terminals of the indicator, and check the lighting condition of the security indicator.

    OK :
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal I22-16 (MHTR)
    Battery negative (-) → Terminal I22-12 (E)
    Security indicator comes on

    NOTICE:
    1. If the positive (+) lead and the negative (-) lead are incorrectly connected, the security indicator will not come on.
    2. Voltage of more than 12 V will damage the security indicator.
    3. If the voltage is too low, the security indicator will not come on.



NG
REPLACE ACCESSORY METER ASSEMBLY (Click here)
OK

REPLACE MAIN BODY ECU