Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM

DTC    B2796    No Communication in Immobiliser System

for Preparation Click here


DESCRIPTION

  1. DTC B2796 is output when a key is inserted into the ignition key cylinder but no communication occurs between the key and transponder key ECU.

DTC Code
DTC Detection Condition
Trouble Area
B2796
  1. A key without an ID code (without a communication IC chip) is inserted into the ignition key cylinder.
  2. Communication is not established within about 20 seconds after the key is inserted.
  1. Key
  2. Harness or connector
  3. Transponder key ECU
  4. Transponder key amplifier

WIRING DIAGRAM


B194317E02


INSPECTION PROCEDURE

HINT:
When the transponder key ECU is replaced, reregister the ECU - ECM communication ID.

1.CHECK WHETHER ENGINE STARTS WITH OTHER KEYS
  1. Check if the engine starts with an already registered vehicle key.

    OK:
    Engine starts.



NG
Go to step 2
OK

REREGISTER KEY CODE OR REPLACE KEY THAT CANNOT START ENGINE 

2.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - TRANSPONDER KEY AMPLIFIER)
B110403E50
  1. Disconnect the H32 ECU connector.

  1. Disconnect the H27 amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H32-14 (VC5) - H27-1 (VC5)
    Always
    Below 1 Ω
    H32-15 (CODE) - H27-4 (CODE)
    H32-4 (TXCT) - H27-5 (TXCT)
    H32-5 (AGND) - H27-7 (AGND)
    H32-14 (VC5) or H27-1 (VC5) - Body ground
    Always
    10 kΩ or higher
    H32-15 (CODE) or H27-4 (CODE) - Body ground
    H32-4 (TXCT) or H27-5 (TXCT) - Body ground
    H32-5 (AGND) or H27-7 (AGND) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE TRANSPONDER KEY AMPLIFIER
  1. Temporarily replace the transponder key amplifier with a new or normally functioning one (Click here).


NEXT


4.CLEAR DTC
  1. Clear the DTC (Click here).


NEXT


5.CHECK FOR DTC
  1. Check for DTC (Click here).

    OK:
    DTC B2796 or B2798 is not output.



NG
REPLACE TRANSPONDER KEY ECU
OK

END (TRANSPONDER KEY AMPLIFIER IS DEFECTIVE)