DTC B2799 Engine Immobiliser System Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2799 |
|
|

| 1.CLEAR DTC |
Clear the DTC (Click here).
| NEXT | |
| 2.CHECK FOR DTC |
Check for DTC (Click here).
|
| ||||
| OK | ||
| ||
| 3.REREGISTER ECU - ECM COMMUNICATION ID |
Reregister the ECU - ECM communication ID.
| NEXT | |
| 4.CLEAR DTC |
Clear the DTC (Click here).
| NEXT | |
| 5.CHECK FOR DTC |
Check for DTC (Click here).
|
| ||||
| OK | ||
| ||
| 6.CHECK CONNECTION OF CONNECTOR |
Turn the ignition switch off.
Check that the connectors are properly connected to the ECM and the transponder key ECU.
|
| ||||
| OK | |
| 7.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - ECM) |
![]() |
Disconnect the H32 ECU connector.
Disconnect the A27 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H32-13 (EFIO) - A27-40 (IMI) | Always | Below 1 Ω |
| H32-12 (EFII) - A27-29 (IMO) | ||
| H32-13 (EFIO) or A27-40 (IMI) - Body ground | Always | 10 kΩ or higher |
| H32-12 (EFII) or A27-29 (IMO) - Body ground |
|
| ||||
| OK | |
| 8.REPLACE TRANSPONDER KEY ECU |
Temporarily replace the transponder key ECU with a new one.
| NEXT | |
| 9.CLEAR DTC |
Clear the DTC (Click here).
| NEXT | |
| 10.CHECK FOR DTC |
Check for DTC (Click here).
|
| ||||
| OK | ||
| ||