Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM

DTC    B2784    Antenna Coil Open / Short

for Preparation Click here


DESCRIPTION

The antenna coil receives key code signals from the transponder chip in the key grip. The coil is built into the transponder key amplifier, which amplifies the key code signals and outputs the signals to the transponder key ECU.
This DTC is output when there is an open or short malfunction in the antenna coil.

DTC Code
DTC Detection Condition
Trouble Area
B2784
  1. When performing immobiliser set/unset, the antenna coil circuit is opened or shorted for 5 seconds.
  2. When performing immobiliser set/unset, the ignition switch is not connected for 5 seconds.
  1. Harness or connector
  2. Transponder key ECU
  3. Transponder key amplifier

WIRING DIAGRAM


B194317E02


INSPECTION PROCEDURE

HINT:
When the transponder key ECU is replaced, reregister the ECU - ECM communication ID.

1.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - TRANSPONDER KEY AMPLIFIER)
B110403E50
  1. Disconnect the H32 ECU connector.

  1. Disconnect the H27 amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H32-14 (VC5) - H27-1 (VC5)
    Always
    Below 1 Ω
    H32-15 (CODE) - H27-4 (CODE)
    H32-4 (TXCT) - H27-5 (TXCT)
    H32-5 (AGND) - H27-7 (AGND)
    H32-14 (VC5) or H27-1 (VC5) - Body ground
    Always
    10 kΩ or higher
    H32-15 (CODE) or H27-4 (CODE) - Body ground
    H32-4 (TXCT) or H27-5 (TXCT) - Body ground
    H32-5 (AGND) or H27-7 (AGND) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT TRANSPONDER KEY ECU (VC5,AGND)
B128338E35
  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    H32-14 (VC5) - Body ground
    No key is in ignition key cylinder
    Below 1 V
    H32-14 (VC5) - Body ground
    Key is in ignition key cylinder
    4.6 to 5.4 V

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H32-5 (AGND) - Body ground
    Always
    Below 1 Ω



NG
REPLACE TRANSPONDER KEY ECU
OK


3.REPLACE TRANSPONDER KEY AMPLIFIER
  1. Temporarily replace the transponder key amplifier with a new or normally functioning one (Click here).


NEXT


4.CLEAR DTC
  1. Clear the DTC (Click here).


NEXT


5.CHECK FOR DTC
  1. Check for DTC (Click here).

    OK:
    DTC B2784 is not output.



NG
REPLACE TRANSPONDER KEY ECU
OK

END (TRANSPONDER KEY AMPLIFIER IS DEFECTIVE)