AUDIO AND VISUAL SYSTEM (for Radio and Display Type) > Speaker Circuit |

| 1.CHECK HARNESS AND CONNECTOR (SPEAKER CIRCUIT) |
Disconnect the I55 and I56 radio and display receiver assembly connectors.
Disconnect the L8*1 and/or M10*2 front No. 1 speaker assembly connector.
Disconnect the I11*1 and/or I13*2 front No. 2 speaker assembly connector.
Disconnect the L1*1 and/or M1*2 front No. 3 speaker assembly connector.
Disconnect the N1*1 and/or N7*2 rear No. 1 speaker assembly connector.
Disconnect the N2*1 and/or N8*2 rear No. 2 speaker assembly connector.
Disconnect the O37*1 and/or O31*2 quarter side speaker assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I55-1 (FR+) - I11-3 (TWR+) | Always | Below 1 Ω |
| I55-5 (FR-) - I11-4 (TWR-) | Always | Below 1 Ω |
| I55-1 (FR+) - L8-1 | Always | Below 1 Ω |
| I55-5 (FR-) - L8-2 | Always | Below 1 Ω |
| I11-1 (+) - L1-3 | Always | Below 1 Ω |
| I11-2 (-) - L1-1 | Always | Below 1 Ω |
| I56-1 (RR+) - O37-1 (+) | Always | Below 1 Ω |
| I56-3 (RR-) - O37-2 (-) | Always | Below 1 Ω |
| I56-1 (RR+) - N1-1 | Always | Below 1 Ω |
| I56-3 (RR-) - N1-2 | Always | Below 1 Ω |
| O37-3 (+) - N2-3 | Always | Below 1 Ω |
| O37-4 (-) - N2-1 | Always | Below 1 Ω |
| I55-1 (FR+) - Body ground | Always | 10 kΩ or higher |
| I55-5 (FR-) - Body ground | Always | 10 kΩ or higher |
| I11-1 (+) - Body ground | Always | 10 kΩ or higher |
| I11-2 (-) - Body ground | Always | 10 kΩ or higher |
| I56-1 (RR+) - Body ground | Always | 10 kΩ or higher |
| I56-3 (RR-) - Body ground | Always | 10 kΩ or higher |
| O37-3 (+) - Body ground | Always | 10 kΩ or higher |
| O37-4 (-) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
| I55-2 (FL+) - I13-3 (TWL+) | Always | Below 1 Ω |
| I55-6 (FL-) - I13-4 (TWL-) | Always | Below 1 Ω |
| I55-2 (FL+) - M10-1 | Always | Below 1 Ω |
| I55-6 (FL-) - M10-2 | Always | Below 1 Ω |
| I13-1 (+) - M1-3 | Always | Below 1 Ω |
| I13-2 (-) - M1-1 | Always | Below 1 Ω |
| I56-2 (RL+) - O31-1 (+) | Always | Below 1 Ω |
| I56-6 (RL-) - O31-2 (-) | Always | Below 1 Ω |
| I56-2 (RL+) - N7-1 | Always | Below 1 Ω |
| I56-6 (RL-) - N7-2 | Always | Below 1 Ω |
| O31-3 (+) - N8-3 | Always | Below 1 Ω |
| O31-4 (-) - N8-1 | Always | Below 1 Ω |
| I55-2 (FL+) - Body ground | Always | 10 kΩ or higher |
| I55-6 (FL-) - Body ground | Always | 10 kΩ or higher |
| I13-1 (+) - Body ground | Always | 10 kΩ or higher |
| I13-2 (-) - Body ground | Always | 10 kΩ or higher |
| I56-2 (RL+) - Body ground | Always | 10 kΩ or higher |
| I56-6 (RL-) - Body ground | Always | 10 kΩ or higher |
| O31-3 (+) - Body ground | Always | 10 kΩ or higher |
| O31-4 (-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.INSPECT FRONT NO. 1 SPEAKER ASSEMBLY |
Remove the front No. 1 speaker assembly (Click here)
Inspect the front No. 1 speaker assembly (Click here).
|
| ||||
| OK | |
| 3.CHECK FRONT NO. 2 SPEAKER ASSEMBLY |
Replace the front No. 2 speaker assembly with a known good one (Click here).
Check that the malfunction disappears.
|
| ||||
| OK | ||
| ||
| 4.CHECK FRONT NO. 3 SPEAKER ASSEMBLY |
Replace the front No. 3 speaker assembly with a known good one (Click here).
Check that the malfunction disappears.
|
| ||||
| OK | ||
| ||
| 5.INSPECT REAR NO. 1 SPEAKER ASSEMBLY |
Remove the rear No. 1 speaker assembly (Click here).
Inspect the rear speaker assembly (Click here).
|
| ||||
| OK | |
| 6.CHECK REAR NO. 2 SPEAKER ASSEMBLY |
Replace the rear No. 2 speaker assembly with a known good one (Click here).
Check that the malfunction disappears.
|
| ||||
| OK | ||
| ||
| 7.CHECK QUARTER SIDE SPEAKER ASSEMBLY |
Replace the quarter side speaker assembly with a known good one (Click here).
Check that the malfunction disappears.
|
| ||||
| OK | ||
| ||