AUDIO AND VISUAL SYSTEM (for Radio and Display Type) > Data Signal Circuit between Radio Receiver and Stereo Jack Adapter |

| 1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
Disconnect the I61 radio and display receiver assembly connector.
Disconnect the I51 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I61-2 (UDO-) - I51-2 (UDO-) | Always | Below 1 Ω |
| I61-3 (UDO+) - I51-3 (UDO+) | Always | Below 1 Ω |
| I61-2 (UDO-) - Body ground | Always | 10 kΩ or higher |
| I61-3 (UDO+) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||