Home › Vehicle Interior › SEAT › REAR POWER SEAT CONTROL SYSTEM

REAR POWER SEAT CONTROL SYSTEM > Back Door Courtesy Switch Circuit

for Preparation Click here


DESCRIPTION

The fold seat control ECU receives signals from the back door courtesy switch and detects the state of the back door (open/close). If the ECU does not detect that the back door is open, the seat folding and return functions are not available.

WIRING DIAGRAM


B218389E01


INSPECTION PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER (BACK DOOR COURTESY SWITCH)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Back Door P/W / Data List.

  1. According to the display on the intelligent tester, read the Data List.

    Back Door P/W 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Back Door Courtesy Switch
    Back door courtesy switch / ON or OFF
    ON: Back door opened
    OFF: Back door closed
    -

    OK:
    When back door courtesy switch operation is performed, the results are the same as above.



NG
GO TO BACK DOOR COURTESY SWITCH CIRCUIT (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (BACK DOOR ECU - FOLD SEAT CONTROL ECU)
B194848E03
  1. Disconnect the V2 ECU connector.

  1. Disconnect the O34 or P20 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LH Side 
    Tester Connection
    Condition
    Specified Condition
    V2-17 (OCTY) - O34-5 (BDCY)
    Always
    Below 1 Ω
    V2-17 (OCTY) or O34-5 (BDCY) - Body ground
    Always
    10 kΩ or higher
    for RH Side 
    Tester Connection
    Condition
    Specified Condition
    V2-17 (OCTY) - P20-5 (BDCY)
    Always
    Below 1 Ω
    V2-17 (OCTY) or P20-5 (BDCY) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE BACK DOOR ECU
  1. Temporarily replace the back door ECU with a new or normally functioning one (Click here).


NEXT


4.CHECK POWER SEAT CONTROL SYSTEM (OPERATION)
  1. Check the power folding function (Click here).

    OK:
    Operate normally.



NG
REPLACE FOLD SEAT CONTROL ECU (Click here)
OK

END (BACK DOOR ECU DEFECTIVE)