Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio and Display Type)

AUDIO AND VISUAL SYSTEM (for Radio and Display Type) > Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter

for Preparation Click here


DESCRIPTION

The No. 1 stereo jack adapter assembly sends an external device sound signal to the radio and display receiver assembly through this circuit.
The sound signal that has been sent is amplified by the radio and display receiver assembly and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the radio and display receiver assembly or speakers.

WIRING DIAGRAM


E280106E08


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
  1. Disconnect the I58 radio and display receiver assembly connector.

  1. Disconnect the I51 No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I58-28 (VAL+) - I51-7 (ALO)
    Always
    Below 1 Ω
    I58-26 (VAR+) - I51-6 (ARO)
    Always
    Below 1 Ω
    I58-27 (VA-) - I51-8 (ASGN)
    Always
    Below 1 Ω
    I58-11 (AGND) - I51-10 (AGND)
    Always
    Below 1 Ω
    I58-25 (ADPG) - I51-9 (AUXO)
    Always
    Below 1 Ω
    I58-28 (VAL+) - Body ground
    Always
    10 kΩ or higher
    I58-26 (VAR+) - Body ground
    Always
    10 kΩ or higher
    I58-27 (VA-) - Body ground
    Always
    10 kΩ or higher
    I58-11 (AGND) - Body ground
    Always
    10 kΩ or higher
    I58-25 (ADPG) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)