AUDIO AND VISUAL SYSTEM (for Radio Receiver Type) > Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter |

| 1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
Disconnect the I3 radio receiver assembly connector.
Disconnect the H7 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I3-17 (ALI) - H7-1 (ALO) | Always | Below 1 Ω |
| I3-15 (ARI) - H7-2 (ARO) | Always | Below 1 Ω |
| I3-16 (ASGN) - H7-3 (ASGN) | Always | Below 1 Ω |
| I3-18 (AUXG) - H7-5 (AUXG) | Always | Below 1 Ω |
| I3-19 (AUXI) - H7-4 (AUXO) | Always | Below 1 Ω |
| I3-17 (ALI) - Body ground | Always | 10 kΩ or higher |
| I3-15 (ARI) - Body ground | Always | 10 kΩ or higher |
| I3-16 (ASGN) - Body ground | Always | 10 kΩ or higher |
| I3-18 (AUXG) - Body ground | Always | 10 kΩ or higher |
| I3-19 (AUXI) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||