Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Sound Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter

for Preparation Click here


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the navigation receiver assembly via this circuit.
The sound signal that has been sent is amplified by the navigation receiver assembly, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the navigation receiver assembly or speakers.

WIRING DIAGRAM


E283433E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
  1. Disconnect the I53 navigation receiver assembly connector.

  1. Disconnect the I51 No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I53-25 (ADPG) - I51-9 (AUXO)
    Always
    Below 1 Ω
    I53-26 (VAR+) - I51-6 (ARO)
    Always
    Below 1 Ω
    I53-28 (VAL+) - I51-7 (ALO)
    Always
    Below 1 Ω
    I53-27 (VA-) - I51-8 (ASGN)
    Always
    Below 1 Ω
    I53-11 (AGND) - I51-10 (AGND)
    Always
    Below 1 Ω
    I53-25 (ADPG) - Body ground
    Always
    10 kΩ or higher
    I53-26 (VAR+) - Body ground
    Always
    10 kΩ or higher
    I53-28 (VAL+) - Body ground
    Always
    10 kΩ or higher
    I53-27 (VA-) - Body ground
    Always
    10 kΩ or higher
    I53-11 (AGND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)