VEHICLE STABILITY CONTROL SYSTEM > VSC OFF Indicator Light Remains ON |

| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication system DTC is output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (VSC OFF INDICATOR LIGHT) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester ON.
Select the Active Test mode and operate the VSC OFF indicator light using the intelligent tester.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| VSC Warning Light | VSC OFF indicator light | Indicator light ON/OFF | Observe combination meter |
Check that the VSC OFF indicator light turns on and off in the combination meter when using the intelligent tester.
|
| ||||
| OK | ||
| ||