TOYOTA PARKING ASSIST-SENSOR SYSTEM > Front Clearance Sonar Sensor RH Circuit |

| 1.INSPECT NO. 2 ULTRASONIC SENSOR (FRONT CORNER SENSOR RH) |
Remove the No. 2 ultrasonic sensor (front corner sensor RH) (Click here).
Inspect the No. 2 ultrasonic sensor (front corner sensor RH) (Click here).
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (FRONT CORNER SENSOR RH - CLEARANCE WARNING ECU ASSEMBLY) |
Disconnect the B2 No. 2 ultrasonic sensor (front corner sensor RH) connector.
Disconnect the H131 clearance warning ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B2-1 (BI) - H131-3 (BOF) | Always | Below 1 Ω |
| B2-3 (SI) - H131-5 (SOF) | Always | Below 1 Ω |
| B2-5 (EI) - H131-4 (E5) | Always | Below 1 Ω |
| B2-1 (BI) or H131-3 (BOF) - Body ground | Always | 10 kΩ or higher |
| B2-3 (SI) or H131-5 (SOF) - Body ground | Always | 10 kΩ or higher |
| B2-5 (EI) or H131-4 (E5) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||